CLOWN TOOL KIT PREZZIE

Decoupaged tool kit for the geek in your life (or your own DIY drawer)

I'm sure everyone is like me: frantically busy, just a little broke, and therefore looking to give handmade prezzies (that don't look HOME made - there is a difference). So I thought a quick and easy project might be just the job! Perfect for anyone, and unusual too! It's a TOOL KIT!

This was inexpensive, but doesn't look too cheap (although the plastic case was a dead giveaway, hence the decoration)

This is just a cheap basic tool kit you'll find in most hardware stores, a good size for changing plugs and other small electrical stuff (women need to be able to do this too, lol) also poking holes in signatures for books, levering out staples, prising drawing pins out of walls etc.

Front and back prepared in exactly the same way - just change the positioning of the decorations

PREPARATION

As it's plastic, it's rather slick and not good for gluing, so sand a little first, just enough to roughen the surface (use an emery board if you don't have sandpaper).

DECORATION

• Couldn't be simpler: leftovers of scrapbooking paper for the front and the back, cut to size. 
• Collage the ticket on first, then overstamped some text (using Staz-On ink).
• The dots were Punchinella (sequin waste) used as a stencil, stippled with acrylic paint. Move the stencil and stipple again, creating a drop shadow using a metallic paint. 
• Finally, decoupage a vintage scrap image of a clown's head.

 I used PVA (white glue) throughout. Mod Podge is also good.

Next step: glue to the tool kit using a good quality strong glue such as Crafter's, Gorilla, Aleene's Tacky Glue or use double-sided tape. You don't want this peeling off at a later date.

Finishing touches: I ran a metallic gold pen round the edges, then applied a single coat of clear acrylic varnish for protection.

TIME TAKEN

Very fast - took around 2 hours including coffee and biscuits, and drying time!